You’d be right to be worried about security with your wireless garage door opener and remote. A burglar can access your garage contents and even your house if you do not follow some easy security actions.
Different radio frequencies are used for communication between the remote and the opener. Tiny switches called dip switches are utilized to adjust the frequency used between the two. It is a wise concept to reconfigure the dip switch settings to ensure your garage is more protected.
A dip switch is a little block of plastic about the size of a dice cut in half. They are typically colored blue or red with 8 to 10 small white switch levers placed up or down. When the up/ down switch patterns match on both devices, will your garage door opener remote control be able to interact with the opener system? By changing the switch pattern, you are changing the radio frequency utilized to interact between the two.
You must quickly locate the dip switch on the opener and the push-button control remote control. But to get access to the dip switch on the remote, you might need to open it up if the dip switch isn’t discovered in the battery compartment. Eliminate the screws holding the remote together, or thoroughly pry it apart if there are no screws. Once you have access to the dip, turn on the small, rush the switch positions, and after that match, the openers dip switch block’s parts. It does not matter what the pattern looks like, so long as it’s a random pattern that would be challenging for somebody to think.
If you have difficulty getting the remote to work after doing this, verify that the dip switch patterns are the same on both systems. Then inspect the small battery is in good condition, and as usual, make sure the opener has power and usually runs using the control panel inside your garage. You might have to check out the manual if all else fails.
If you are considering getting a brand-new garage door opener or having already acquired one, you will wish to alter settings to guarantee everybody is honest. Do not forget, your installer or anybody dealing with him understands your frequency switch settings unless you change them. So go on and blend the switch pattern settings and test that it works.
Even if you are a garage door opener installation do-it-yourself type, you’ll wish to make the very same modifications. Do not just stay with the factory default settings. If you did, then anybody could drive down your street with a compatible remote up until he discovers a door that opens and gives access to your house. Make sure that’s not you.
These suggestions also apply to anyone buying or renting a new home too. Like you may alter the lock to ensure no spare keys are floating around that could jeopardize your house security. You have no way of knowing the number of previous homes there may have been. And you wouldn’t desire somebody to walk right into your garage or house.